Hobbico Awarf Series, Руководство пользователя

Страница: 22 / 40

Mounting the engine
❑
1. The picture shows an O.S. 40 FP engine
mounted. Mount the engine by using two engine
mounting brackets, four 4 x 15mm screws, four 4mm
lock washers, and four 4mm nuts. The engine
centerline must be inline with the fuselage centerline.
Place the engine on the mount and secure the engine
with the engine brackets. The lock washers should be
located on top of the bracket under the head of the
screw. The screws are secured by four 4mm nuts.
Note: Thread locking compound is recommended for
use on the engine mounting screws.
Attaching the muffler
❑
2. Locate the muffler and mount it to the engine by
using two 3 x 30mm machine screws. The exhaust outlet
should be pointing down and away from the fuselage.
Running the fuel line
❑
3. Run the fuel lines to the proper locations on the
engine (fuel pick-up to the carburetor, pressure line
to the muffler, and fill line on the same side as the fuel
pick-up line).The fill line should be plugged with a
3mm screw (not included).
Installing the pushrod connector
❑
4. Remove the wire control rod from the plastic
guide tube. Slide a pushrod connector on one end of
the rod, leaving 1/4" (6mm) extending past the
connector. Tighten the screw located on the
connector using a standard screwdriver.
22
Engine Installation
What you'll need –
Parts in this kit ...Plus, these general items:
• Fuel line • Standard screwdriver
• Spinner • Phillips screwdriver
• 2-2 x 12mm S/T screws • Needle nose pliers
• 2 Engine mounting brackets • Thread locking compound
• 4-4 x 15mm screws
• 10mm wrench
• 4-4mm lock washers • 3mm screw
• 4-4mm nuts • Pushrod connector
Pushrod Connector
Actual Size
Carb line
Pressure line
Fill line
Engine mounting bracket
Pushrod connector
Engine Mounting
Bracket(2), Bolt(4),
Washer(4), Nut(4)
Actual Sizes