Installing the pushrod
❑
38. Locate the 17-3/4" (450mm) wire control rod
and make a 1/4" (6mm)
Z-bend
on one end of the
rod. Run the control rod through the plastic guide
tube in the fuselage and insert the Z-bend into the
inside hole of the steering control horn from the top
side when the plane is right-side up.
Throttle control guide
❑
39. Insert the plastic pushrod guide tube into the
predrilled hole in the engine compartment firewall.
Leaving 1/4" (6mm) of the tube showing, glue the
throttle control tube into the firewall using thin CA.
Insert the control rod
❑
40. Insert the wire control rod into the guide tube,
leaving 1/2" (12.5mm) exposed.
Fuel tank assembly
❑
41. Locate the three aluminum tubes that are used
in the
fuel tank.
The longest one will be used as the
pressure line.
Bending the pressure line
❑
42. Being careful not to kink the tube, bend one end
of the tube to a 90 angle. It may be helpful to find a
rigid object that can be used as a form to bend the tube
around. Leave 1-1/2" (38mm) of straight tube at one
end so it can easily be inserted through the tank plug.
Assembling the tank plug
❑
43. Locate the plastic plug discs (2). Push the
aluminum tubes through the smaller stopper disc and
the back of the rubber plug. Place the larger stopper
disc on the opposite side and insert the 3 x 18mm self
tapping screw through the larger disc, rubber plug
and then into the smaller disc. Do not tighten the
screw at this time.
20
3 x 18mm Screw (1)
Actual Size
Pushrod guide
tube
Control rod
Содержание Awarf Series
Страница 1: ...Easy as 1 2 3 V1 3 Copyright 1998 ...
Страница 40: ......