Hobbico Awarf Series, Руководство пользователя

Страница: 11 / 40

11
Installing the aileron control horns
❑
22. Locate the aileron control horns on the plastic
parts tree. Remove the control horns and thread them
onto the torque rods until there is 3/4" (19mm) of
torque rod between the wing and control horn.
Assembling the pushrods
❑
23. Locate the two plastic clevises on the plastic
parts tree and two 8" (203mm) aileron control rods.
Thread the clevises onto the
pushrods in a clockwise
motion until the rod starts to protrude from the inside
of the clevis between the forks.
Installing the pushrods
❑
24. Attach the aileron control rods to the aileron
torque rods using the plastic clevises. Pry the fork of
the clevis apart and insert the pin of the clevis through
the hole in the aileron control horn. Press the forks of
the clevis back together until they snap into place.
Aileron pushrods installed
❑
25. Locate the 1/4" (6.5mm) diameter clear plastic
tubing and cut two 1/4" (6.5mm) long pieces. Do not
use the medium silicone fuel tubing. Slide one piece
on each of the two control rod clevises to secure the
connection between the clevis and the horn.
11
Aileron Control Horn (2)
Actual Size
Clevis (2)
Actual Size
Bottom of wing
Aileron control horn
Clevis
Aileron pushrod
Clevis
Aileron torque rod
Tubing goes here