Hobbico Awarf Series, Руководство пользователя

Страница: 16 / 40

Installing the vertical stabilizer
❑
19. Mix 1/4oz. (7.5ml) of 30-minute epoxy to glue
the vertical stabilizer in place. Using a mixing stick,
apply epoxy to the top of the horizontal stabilizer
through the vertical stabilizer slot. Apply epoxy to the
sides and bottom surfaces of the fin base that have
balsa wood exposed. Insert the vertical stabilizer into
the slot, making sure the fin root is seated firmly on
the horizontal stabilizer. Check for a perpendicular
angle between the fin and the stabilizer when viewed
from the front. It is critical that the fin remains
perpendicular while the epoxy is curing. T-pins or
masking tape may be required to hold the fin during
this time.
The stabilizers installed
Check the elevator
❑
20. The CA hinges in your plane are preglued and
must not be removed. Check the elevator hinges to be
sure that they are secure. Gently tug on the control
surface at each hinge location. If any of them seem
loose, reglue them as described on page 10.
Check the rudder
❑
21. Check the rudder hinges to be sure that they are
secure. Gently tug on the control surface at each hinge
location. If any of them seem loose, reglue them as
described on page 10.
Rudder and elevator move freely
Locations of the control horns
❑
22. Notice the locations and alignment of the
control horns in both the photo and the illustration
before marking and drilling.
Control horn alignment
16
Rudder control horn
Elevator control horn
Stabilizer centerline
3/4"
3/4"