Hioki SW9001, Инструкция по эксплуатации

Страница: 98 / 170

94
Message Reference
Device-specific commands
(1) Event Status Register
Query Condition Register of Standard Operation Register Group
Syntax Query
:STATus:OPERation:CONDition?
Response <0 to 65535 (NR1)>
Description Returns the present standard operation register value. Unused bits (indicated in the
following chart by “–”) return the value 0.
bit 15 bit 14 bit 13 bit 12 bit 11 bit 10 bit 9 bit 8
– – ERR – CLOSE REMOTE – –
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
– –
WAIT_
TRG
SCAN – – – –
Example
:STAT:OPER:COND?
1024
The device is in the remote state.
Note
• The present status is returned when this command is received.
•Unlike
:STATus:OPERation:EVENt?
, :
STATus:OPERation?
, bit information is not
retained.
Query Event Register of Standard Operation Register Group
Syntax Query
:STATus:OPERation[:EVENt]?
Response <0 to 65535 (NR1)>
Description Returns the retained standard operation register value. Unused bits (indicated in the
following chart by “–”) return the value 0.
bit 15 bit 14 bit 13 bit 12 bit 11 bit 10 bit 9 bit 8
– – ERR – CLOSE REMOTE – –
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
– –
WAIT_
TRG
SCAN – – – –
Example
:STAT:OPER:EVEN?
1024
The device is in the remote state.
Note
• When an event occurs, 1 is set for the bit corresponding to each event and retained.
•The bit is not cleared until
*CLS
or this query is executed or the power is turned on again.
Set and query Enable Register of Standard Operation Register Group
Syntax Command
:STATus:OPERation:ENABle <0
-
65535(NR1)>
Query
:STATus:OPERation:ENABle?
Response <0 to 65535 (NR1)>
Description
Sets the SRER mask pattern to a value from 0 to 255. The value when the device is
turned on is 0. When issued as a query, unused bits are always set to 0.
bit 15 bit 14 bit 13 bit 12 bit 11 bit 10 bit 9 bit 8
– – ERR – CLOSE REMOTE – –
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
– –
WAIT_
TRG
SCAN – – – –
Note The initial value when the power is turned on is 0.
HIOKI SW1001A961-04