Hioki SW9001, Инструкция по эксплуатации

Страница: 8 / 170

4
Safety Information
Safety Information
Be sure to also read the separate document “Operating Precautions” before use.
Usage Notes
Check before use
Follow these precautions to ensure safe operation and to obtain the full benefits of the various
functions.
WARNING
If a connection cable or the device is damaged, there is a risk of an electric shock.
Perform the following inspection before using the device.
•
Before using the device, check that the coating of the connection cables are
neither ripped nor torn and that no metal parts are exposed. Using the device
under such conditions could result in an electric shock. Replace any damaged
cable with a new one.
•
Before using the device the first time, verify that it operates normally to ensure
that no damage occurred during storage or shipping. If you find any damage,
contact your authorized Hioki distributor or reseller.
This device is designed to measure voltages of 60 V or lower. Do not input
voltages over 60 V or measure locations exceeding 60 V from the ground potential.
If the relay of the device fails, the battery of the measuring object may be shorted
(p. 148).
Installing the device and module
CAUTION
Do not position the device on an unstable table or inclined surface. Dropping or
knocking down the device can cause injury or damage to the device.
Installing
To prevent overheating, be sure to leave the specified clearances around the device.
• The device should be operated only with the bottom side downwards.
Rear: 10 mm or more Side: 50 mm or more
HIOKI SW1001A961-04