14
────────────────────────────────────────────────────
4.2 Setting the 9442 PRINTER Communication Conditions
────────────────────────────────────────────────────
Switch No.
Function
ON
OFF
1
Input method
Parallel
Serial
2
Printing speed
High
Low
3
Auto loading
ON
OFF
4
CR function
Carriage return
and line feed
Carriage return
5
DIP SW setting
command
Enable
Disable
6 to 8
Printing density
See the table below.
Printing density (%)
Switch No.
100
6
7
8
OFF
ON
ON
Switch No.
Function
ON
OFF
1
Data bit length
8 bits
7 bits
2
Parity permission
None
With parity
3
Parity condition
Odd
Even
4
Flow control
H/W BUSY
XON/XOFF
5 to 8
Baud rate
See the table below.
Baud rate
(
bps
)
Switch No.
19200
5
6
7
8
OFF
ON
ON
OFF
4.2 Setting the 9442 PRINTER Communication
Conditions
The 9442 is shipped with the function settings for use with the HIOKI 3166
CLAMP ON POWER HiTESTER. Before using, always change the settings of
the DIP switches.
Change the settings of the DIP switches as follows. For more information on
settings, refer to the instruction manual for the DPU-414 supplied to the 9442.
Setting the 9442 PRINTER
:
Use these settings.
(1) Software DIP SW1
(2) Software DIP SW2
It has been set to the DPU-414 default setting.
(3) Software DIP SW3
Setting the 9593-02 RS-232C INTERFACE
Set all the communication condition setting switches on the RS-232C panel to
ON.
Содержание 9593-02
