HikRobot MV-CL021-40GM, Руководство пользователя

Страница: 74 / 126

GigE Line Scan Camera
·
User Manual
65
The camera has 2 types of gain, including the analog gain and digital gain. The analog gain is
applied before the signal from the camera sensor is converted into digital values, while digital gain
is applied after the conversion.
When increasing the analog gain, the image noise will increase too, which will influence image
quality. If you want to increase image grayscale value, it is recommended to increase the camera’s
exposure time. If the exposure time reaches its upper limit, and at this point, you can increase
analog gain.
10.10.1 Set Analog Gain
For different models of the camera, the analog gain range and setting method may be different,
please refer to the actual one you got.

Gain
The camera supports 3 types of analog gain modes: Off, Once and Continuous. Click Analog
Control, and select Gain Auto according to actual demands. The analog gain mode and principle
are shown below.
Table 10-3 Analog Gain Mode and Principle
Gain Mode Principle
Off The camera adjusts gain according to the value configured by
user in Gain.
Once Adjust the gain automatically according to the image
brightness. After adjusting, it will switch to Off Mode.
Continuous Adjust the gain continuously according to the image brightness.
When the analog gain is set as Once or Continuous, the gain should be within the range of Auto
Gain Lower Limit and Auto Gain Upper Limit.
Figure 10-23 Set Gain under Once or Continuous Mode