Hewlett Packard Enterprise HPE ProLiant DL385 Gen10 Plus, Руководство по техническому обслуживанию и ремонту

Страница: 59 / 179

Removing and replacing a GPU enablement board
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the power cord to
remove power from the server. The front panel Power On/Standby button does not shut off system power. Portions of
the power supply and some internal circuitry remain active until AC power is removed.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either
an expansion slot cover or an expansion board installed.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
6. Release the full-length expansion board retainer.
7. Remove the PCIe riser cage:
• Remove the primary PCIe riser cages
• Remove the secondary and tertiary PCIe riser cage
8. Disconnect the power cable from the GPU.
9. Remove the GPU enablement board from the GPU-enabled riser cage:
• Primary riser cage
Removal and replacement procedures
59