Hewlett Packard Enterprise HPE ProLiant DL385 Gen10 Plus, Руководство по техническому обслуживанию и ремонту

Страница: 111 / 179

7. Remove the thermal interface protective cover from the new heatsink.
8. Install the heatsink.
CAUTION: To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink
contact surface, hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
CAUTION: To prevent thermal failure or component damage, do not move the heatsink once the bottom of its
base plate touches the top of the processor. Excessive heatsink movement can cause the thermal grease to smear
and become uneven. Voids in the compound can adversely impact the transfer of heat away from the processor.
CAUTION: Heatsink screws must be tightened and loosened in alternating sequence as shown on the heatsink
label. Do not overtighten the screws as this might damage the system board or the processor socket.
a. Position the heatsink on top of the processor, ensuring that it is properly seated before securing the screws.
b. Use a T-20 screwdriver to tighten the captive screws in the sequence specified on the heatsink label until fully seated.
Removal and replacement procedures
111