Hettich ZENTRIMIX 380 R, Руководство по эксплуатации

Страница: 48 / 88

en Rev. 03 / 02.2021 AB3200 48 / 88
Software description
1 20 9/;\9 1500 2:00
PROG T/°C RCF RPM t/min
T/°C = 20
PROG T/°C RCF RPM t/min
T/°C = 0
PROG T/°C RCF RPM t/min
(1) 68 9/;\9 1500 2:00
PROG T/°C RCF RPM t/min
x
y
Acc time > Run time
PROG T/°C RCF RPM t/min
1 20 9/;\9 1500 2:00
PROG T/°C RCF RPM t/min
_/; = 9 t=00:00:07
PROG T/°C RCF RPM t/min
7.2.1 Temperature (t/°C)
The temperature can only be set for devices with a cooling
unit.
The temperature can be input in degrees Celsius (°C) or
degrees Fahrenheit (°F).
Setting the temperature unit
⮫
Chapter 7.3.5.4 ‘Temp Unit’
on page 63. If degrees Fahrenheit (°F) is set as the tem-
perature unit, the letter ‘F’ appears after the temperature
value on the display.
To set the temperature, proceed as follows:
1. Press the
[T/°C] key.
2. Use the
[adjusting knob] to set the desired value.
3. Press the
[START] key or [T/°C] key to accept the value.
4. Save the program
⮫
Chapter 7.1.2 ‘Save programs (STO 1-99)’
on page 44.
7.2.2 Start-up and run-down parameters
The set start-up and run-down parameters are displayed.
The start-up and run-down parameters can be activated/
deactivated
⮫
Chapter 7.3.5.5 ‘Ramp Unit’ on page 64.
x (
/
) 1-9 = start-up stage, t = start-up time
y (
\
) 1-9 = braking level, 0 = unbraked run-down, t
= run-down time
7.2.2.1 Start-up stage and start-up time
It is only possible to set start-up times when these are acti-
vated
⮫
Chapter 7.3.5.5 ‘Ramp Unit’ on page 64.
If a start-up time is set which is longer than the running
time, no centrifuge run can be started. ‘Acc time > Run
time’ is displayed
⮫
Chapter 9 ‘Troubleshooting’
on page 72.
To set the start-up level and start-up time, proceed as follows:
1. Press the
[Start-up and run-down parameters] key.