Herz firematic PELLET 120, Руководство по эксплуатации

Страница: 44 / 94

9 T-CONTROL
44
Term Description Unit
Time 1
1 - 3 times can be set. The second and third time can be added by the +.
Example:
▪
time 1: 08:00
– 10:00
▪
time 2: 15:00
– 21:00
▪
time 3: 00:00
– 00:00
-
08:00
– 11:00
Setting up individual hot water tank loading times of every weekday -
By pressing the symbol Monday preset gets assigned to remaining
weekdays
-
Barrier times 4 5
Time 1
1 - 2 times can be set. The second time can be added by the +. Example:
see time program.
-
08:00
– 11:00
Setting up individual hot water tank loading times of every weekday,
when it will be not heated
-
By pressing the symbol Monday preset gets assigned to remaining
weekdays.
-
Menu "Heat curve"
Heat curve 1 1
2
Heat curve -
Heat curve 2
1
2
Flow max.
temperature Setting up the maximum flow temperature (30-95) of chosen heating
circuit.
°C
Root point
temperature Setting up the minimum flow temperature (20-70) of chosen heating
circuit
°C
Flow temperature at
+10°C Setting up the flow temperature (20-90) of chosen heating circuit at
+10°C outside temperature
°C
Flow set temperature
at adjustable outside
temperature
Setting up the flow temperature (25-95) of chosen heating circuit at a
adjustable outside temperature
°C
Adjustable outside
temperature Setting up the outside temperature (-20 - 0) of chosen heating circuit
regarding flow must temperature
°C
Switch off temperature
Setting up the outside temperature (5-40)at which the chosen heating
circuit switches off if this temperature is exceeded.
°C
Operation mode „Screed drying“
After „Screed drying“ mode selection the shown flow temperature sequence gets started immediately. If a
lower flow temperature is desired, the flow temperature can be set up with the parame
ter „Flow max.
temperature“. If screed drying is interrupted caused by a fault (power breakdown, etc.), the program (after
fault correction) continues drying as shown automatically. A optional continuing day can be selected with
parameter „Screed days“. After screed drying completion the boiler will switch to "heating time mode". The
desired temperature can be set for each day (end of the program with setpoint= 0°C).