Operation Manual
BinTra
c Operator’s Manual Ver. 3.18 Rev. 1.01
6
Part Number MAN-000004-2
System Settings
The SETUP mode is used to configure the one-time system setup settings for each bin.
If there is no activity for five minutes while in the SETUP mode, the system will exit
SETUP mode and return to auto
sequence mode.
Accessing the SETUP mode
1.
Ver 3.18 & up (All BT260s and some BT200s)
- Press and hold the BIN key until
is displayed, then release the BIN key. The display will then move to
the bin selection as show below.
Segmented display:
Ver 3.17 & below (most BT200s)
- Press and hold the BIN key until
is
displayed, then release the BIN key. The display will remain on SETUP as shown
below.
Segmented display:
Navigating Setup mode
To navigate through the options in SETUP mode, use the UPPER
and LOWER
keys to cycle through the options/parameters. See
Figure 1
for the SETUP menu flow chart.
Selecting an Option in Setup mode
To select an option/parameter to edit in SETUP mode, navigate to the option you wish to
edit using the UPPER
and LOWER
keys and then press the BIN key.
Figure 1
