Henny Penny Wendy's Evolution Elite EEG-251, Руководство оператора

Страница: 32 / 90

Operation
20
1 1))
Make sure basket support is in vat and vat is filled with oil to the proper level.
2 2))
Move power switch to the on position then press the heat button to turn on heat
for the desired vat. If display shows “IS POT FILLED?” make sure oil is at the
proper level and then press ✓ for “YES”. Unit automatically goes into the Melt
Cycle until the oil temperature reaches 180°F (82°C) and then control
automatically exits the Melt Cycle.
NOTE: If desired, the melt cycle may be bypassed by pressing and holding the “✓” or
“X” button for five seconds. The control then shows “EXIT MELT” “YES NO”. Press
“✓” button for yes and vat heats continuously until the set-point temperature is
reached.
3 3..5 5 B Ba assiicc O Op pe erra attiio on n
The evolution Elite fryer is available as non-auto-lift and auto-lift models. The auto-lift
controls allow the basket to be automatically lowered into the shortening at the
beginning of the cook cycle, and raised from the shortening at the end of the cycle.
1 1))
Once out of the Melt Cycle, “LOW TEMP” flashes until the set-point temperature
is reached and the product name shows in the display, ex.: “FRY”. Product can
now be placed in the oil.
2 2))
Press timer 1 or 2.
3 3))
Display shows the name of the product cooking (ex: “FRY”) and the timer
counting down.
4 4))
When cook cycle is complete, an alarm sounds and display shows “DONE”.
5 5))
Press the timer button under “DONE” to stop the alarm, and lift basket from vat.
6 6))
If a Quality Timer (hold timer) has been programmed, the hold time starts
automatically when the user presses the timer button to end the cook cycle.
While the quality timer counts down, the display shows the three-digit product
abbreviation followed by “Qn”, where “n” is the number of minutes remaining.
ex: “FRY” / “Q5” / “FRY” / “Q5” / “FRY” / “Q4”, etc.
7 7))
At the end of the timer countdown, control beeps and the display shows “QUAL”
followed by the three-digit product name: “QUAL” / “FRY” / “QUAL”/ “FRY”.
Press the timer button to cancel the timer.
NOTE: To stop a cook cycle at any time, press and hold timer 1 or 2.
3 3..6 6 IId dlle e M Mo od de e
Once programmed, the Idle Mode helps save on oil and utility costs by lowering the
set-point of the oil when the vat is not being used. To activate the Idle Mode, press
product 0, or can be programmed to activate automatically after “X” minutes of
inactivity on the vat.
The oil is maintained at a lower temperature until the cancel button is pressed, and
then the oil is heated to cooking temperature. See Special Program Mode .