Hawkeye Mfg AGCO RoGator A Series, Руководство по установке

Страница: 32 / 54

CHAPTER 5
28 Hawkeye® 2 Installation Manual for AGCO RoGator A/B-Series (RG900, RG1100, RG1300)
6. Secure the RCM - Sprayer (P/N 063-0173-956) to the plate using the supplied bolts (M6 x75mm (qty 2), M6 x
65mm (qty 1), and flanged nylon lock nuts (qty 3)). It is recommended to mount the RCM - Sprayer to the inside
of the mounting plate.
FIGURE 5. RCM - Sprayer Mounted
RCM - SPRAYER MOUNTING WITH RAVEN AUTOBOOM XRT
If the Raven Autoboom XRT system is installed on this machine, the Autoboom XRT ECUs are mounted in this
same location, so alternative RCM - Sprayer mounting steps are required:
1. Remove the hardware securing the Autoboom XRT REM to the mounting plate.
2. Place the RCM - Sprayer on the opposite side of the mounting plate from the REM, aligning with the mounting
holes.
NOTE: Some drilling may be required depending on the revision of the mounting plate.
3. Use the provided M6 x 110mm (qty 1) and M6 x 140mm (qty 2) bolts, along with M6 washers and M6 flanged
nylon lock nuts to pass through both ECUs and fasten them to the mounting plate, one ECU on each side of the
plate.