Hawkeye Mfg AGCO RoGator A Series, Руководство по установке

Страница: 37 / 54

Install the Hawkeye® 2 RCM - Sprayer: RCM - Sprayer Installation 33
INSTALL THE HAWKEYE® 2 RCM - SPRAYER
4. Disconnect the black connector from the boom/speed node and connect to the black receptacle on the new
ISO boom/speed ECU.The existing boom/speed node will not be reused with the Hawkeye® 2 system and may
be set aside.
SECTION VALVE CABLE CONNECTIONS
1. Disconnect the two brown “AccuBoom Tee” connections located earlier in the installation process.
2. Locate the existing plug and receptacle labeled with an ‘A1’ and ‘A2’ or ‘N1’ and ‘N2’ at the base of the label and
connect these two together.
FIGURE 11. A1 and A2 Connectors
3. Locate the existing female “AccuBoom Tee” receptacle labeled ‘E1’ or ‘KB1’ and connect to the brown receptacle
on the supplied Hawkeye® 2 Retrofit Cable (P/N 115-2005-084).
4. Locate the existing male “AccuBoom Tee” plug labeled ‘E2’ or ‘KB2’ and connect to the brown receptacle on the
Hawkeye® 2 ECU Cabinet cable (P/N 115-7303-317).
NOTE: The remaining 12-pin plug and receptacle lead to the AccuBoom node which is no longer used with
the Hawkeye® 2 system. These connectors will not be used. Connect this plug and receptacle
together to protect the pins from corrosion.
After Hawkeye® 2 system installation is complete, if the boom switches or valves do not operate
correctly, it is possible the wrong connectors were identified above. Switching connectors should
correct the issue.
5. Tuck cables back into the ECU cabinet and replace the cover.