CHAPTER 5
30
Hawkeye® 2 Installation Manual for AGCO RoGator A/B-Series (RG900, RG1100, RG1300)
8. Use a 1/2” hole saw to drill a hole through the back of the ECU cabinet in a location where additional
harnessing will not interfere with the existing electrical components.
NOTE:
Use care to not damage any existing electrical components while drilling. This hole will be used later
to connect the chassis cable to the ECU cabinet cabling for final system connections.
FIGURE 7. Access to ECU cabinet for Hawkeye Chassis Cable
9. Locate the Hawkeye® 2 ECU cabinet cable (P/N 115-2005-317) and remove the nut and washer from the large,
round receptacle.
10. Feed the receptacle through the previously drilled hole on the outside of the ECU cabinet.
11. Replace the washer and nut onto the receptacle from the back of the ECU cabinet.
12. Route the opposite end of the cable harness through the ECU cabinet to the front side. This end of the cable
will be connected in later steps.
13. Reinstall the node mounting plate into the ECU cabinet and use a socket and socket extension to secure the
plate in place with existing hardware.
14. Reuse the hardware from the boom/speed sense node or single product node to mount the new ISO Boom
Speed Sense ECU (P/N 063-0173-635) to the side of the node mounting plate facing toward the front of the
machine.
Drill 1-1/2” Hole
Содержание AGCO RoGator A Series
