Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 7 / 38

7
21. USE ONLY saw blades recommended with warning
that the riving knife shall not be thicker than the
width of the groove cut by the saw blade and not
thinner than the body of the saw blade.
22. USE PUSH-STICK OR PUSH BLOCK to feed the
workpiece past the saw blade. The push-stick
or push block should always be stored with the
machine when not in use.
23.
DIRECTION OF FEED.
Feed work into a blade
against the direction of rotation of the blade. Never
feed material from the back of the saw as the blade
can launch the workpiece at great velocity across
the tabletop.
24. NEVER OPERATE THE SAW ON THE FLOOR .
25. DOUBLE CHECK ALL SETUPS . Make sure the
blade is tight and not making contact with saw or
workpiece before connecting to power supply. Make
sure the table insert and all guards are tight and in
place.
TABLE SAW SAFETY
26. NEVER ATTEMPT TO PLUNGE CUT INTO A
WORKPIECE by placing it on top of the spinning
blade. The workpiece will kickback.
27. USE THE PROPER TABLE INSERT FOR THE
WIDTH AND DIAMETER OF THE DADO BLADE.
Be sure to check that the blade does not contact the
insert before plugging in and turn on the saw. Never
perform bevel cuts with the dado blade.
28.
NEVER GANG CROSSCUT
, lining up more
than one workpiece in front of the blade (stacked
vertically, or horizontally outward of the table) and
then pushing thru saw blade. The blade could pick
up one or more pieces and cause a binding or loss
of control and possible injury.
29. MAKE SURE THE TABLE INSERT IS FLUSH OR
SLIGHTLY BELOW THE TABLE SURFACE on
all sides except the rear. NEVER operate the saw
unless the proper insert is installed.
30. FOLLOW ALL SAFETY INSTRUCTION LABELS
THAT APPEAR ON THE FRONT OR SIDE OF
YOUR TABLE SAW
.