Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 23 / 38

23
OPERATION
BASIC SAW OPERATIONS
RAISE THE BLADE (FIG. HH)
To raise or lower the blade, turn the blade elevation
handwheel (1) to the desired blade height, and then
tighten the bevel lock handle (2) to maintain the desired
blade angle.
TILTING THE BLADE
Two methods are available for tilting the saw blade.
Rapid blade tilting:
Loosen the blade lock handle (2), move the handwheel
(1) to the desired angle, then tighten the bevel lock
handle.
Fine adjustment blade tilting:
Loosen the blade lock handle (2), push in the handwheel
(1) and at the same time turn the handwheel (1) to tilt
the saw blade. When the saw blade is at the desired
angle, tighten the blade lock handle (2).
ON/OFF SWITCH (FIG. II)
The ON / OFF switch has a safety removal key. With the
yellow safety key removed from the switch, unauthorized
and hazardous use by children and others is minimized.
1. To turn the saw ON, insert the safety switch key
(1) into the slot in the switch (2). Move the switch
upward to the ON position.
2. To turn the saw OFF, move the switch downward.
3. To lock the switch in the OFF position, grasp the end (or
yellow part) of the safety switch key (1), and pull it out.
4. With the safety removal key removed, the switch will
not operate.
5. If the safety removal key is removed while the saw
is running, it can be turned OFF but cannot be
restarted without inserting the safety removal key (1).
OVERLOAD PROTECTION (FIG. II)
This saw has an overload reset button (3) that resets the
motor after it shuts off due to overloading or low voltage.
If the motor stops during operation, turn the ON / OFF
switch to the OFF position. Wait about five minutes for
the motor to cool, the push the reset button (3) and turn
the switch to the ON position.
USING THE DUST CHUTE (FIG. JJ)
To prevent fire hazard, clean and remove sawdust
from under the saw frequently.
To prevent sawdust buildup inside the saw housing,
attach a vacuum hose (1) to the 2-1/2 in. diameter dust
port (2) at the rear of the table saw. DO NOT operate
the saw with the hose in place unless the vacuum is
turned on.
USING THE TABLE EXTENSION (FIG. KK)
NOTE:
Use the scale on the front rail for rip cuts up
to 13 in. For rip cuts greater than 13 in. set the lock
the fence on the 13 in. mark. Unlock the extension
table, and slide the table with the fence to the desired
dimension using the scale on the rear rail.
1. Release the cam locking lever (1).
2. Slide the table extension to the desired measurement
and then tighten the cam locking lever.
1
2
1
2
3
1
2
Fig. HH
Fig. II
Fig. KK
Fig. JJ
1
13
WARNING
!