Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 22 / 38

22
ADJUSTING THE LOCKING LEVER (FIG. GG)
If the extension table moves when it is open and locked
in place, the cam locking lever (1) may be loose and
require adjustment. To adjust the locking lever tension,
turn the bar (2) with a 10 mm wrench until it is tightened
correctly. Do not over tighten.
1
1
2
TABLE EXTENSION SCALE POINTER (FIG. DD)
The table extension scale pointer (1) should be at
13 in. on the scale when the extension is in the closed
position. If not, loosen the holding screw (2), position the
pointer over the 13 in. marker and re-tighten the screw.
AUTOMATIC POWER CORD RECOIL SYSTEM
(FIG. EE)
1. To extend the power cord, release by lifting up on
the locking lever, then pull the power cord to the
desired length and then lock the lever into position.
2. To return the cord to storage, release the locking
lever, softly pull the power cord out to retract the
cord fully, then lock the lever.
NOTE:
If part of the cord is covered with dirt, mud or
water it is recommended that you clean it with a rag
before retracting the cord back into storage.
ADJUSTING THE REAR TABLE EXTENSION (FIG. FF)
1. The rear table extension (1) should be positioned as
close as possible to the rear of the table when ripping
short material.
2. The rear table extension (1) should be fully extended
when ripping longer materials that require extra support.
1
2
13
Fig. DD
Fig. EE
Fig. FF
Fig. GG