Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 18 / 38

18
BLADE GUARD ASSEMBLY (Fig. P, Q, R)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
•
When installing the blade guard, cover the blade
teeth with a piece of folded cardboard to protect
yourself from possible injury.
• Never operate this machine without the blade
guard in place for all through sawing operations.
Installing the blade guard and anti-kickback pawl
assembly (Fig. P, Q, R)
1. Make sure the blade is elevated to its maximum
height and the bevel is set at 0°. Make sure the
bevel lock handle is tight.
2. Raise the riving knife to its highest position. Take the
anti-kickback pawl assembly and lift up the locking
lever (1) located on top. (Fig. P)
3. Place the front of assembly into slot (2-Fig. P) and
push down making sure the assembly is engaged
in the slots. There should be no movement of the
assembly. Push down on the locking lever (1). (Fig Q)
4. Take the blade guard assembly and locate the red
sliding locking knob (4) on the back of assembly.
(Fig. R)
5. Insert the blade guard assembly onto the riving knife
so that the pin (5) engages into slot (6) completely.
(Fig. R)
6. Slide the red locking knob (4) up and press the guard
assembly down so that the entire assembly is flat on
the riving knife. Release the red locking knob (4).
7. Make sure that the assembly is locked in place both in
front and back.
Removing the blade guard and anti-kickback pawl
assembly (Fig. P, R)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
1. With the blade elevation handwheel raise the blade
to the maximum height.
2. Loosen the blade lock handle do not pull on handle
just turn and move the handwheel to 90° on the bevel
scale.
3. Tighten the bevel lock handle.
4. Remove the anti-kickback pawl assembly (3) by
pressing the anti-kickback pawls lever (1). (Fig. P)
5. Remove the blade guard assembly (7) by pulling out
the red locking knob (4). (Fig. R)
AVOID KICKBACKS (Fig. S)
(Work thrown back towards you) by keeping the blade
sharp, the rip fence parallel to the saw blade and by
keeping the riving knife, anti-kickback pawls and guards in
place, aligned and functioning. Do not release work before
passing it completely beyond the saw blade. Do not rip
work that is twisted, warped or does not have a straight
edge to guide it along the fence. Do not attempt to reverse
out of a cut with the blade running.
Fig. P
Fig. Q
Loosen
1
2
3
Tighten
1
WARNING
!
WARNING
!
Fig. R
4
6
5
7
1
2
Fig. O