Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 28 / 38

28
MAINTENANCE
MAINTAINING YOUR TABLE SAW
GENERAL MAINTENANCE
For your own safety, turn the switch OFF and
remove the switch key. Remove the plug from
the power source outlet before maintaining or
lubricating your saw.
1. Clean out all sawdust that has accumulated inside
the saw cabinet and the motor.
2. Polish the saw table with an automotive wax to keep
it clean and to make it easier to slide the workpiece.
3. Clean cutting blades with pitch and gum remover.
4. A worn, cut, or damaged power cord should be
replaced immediately.
All electrical or mechanical repairs should be
attempted only by a trained repair technician.
Contact customer service for assistance. Use only
identical replacement parts. Any other parts may
create a hazard.
5. Use liquid dishwashing detergent and water to clean
all plastic parts.
NOTE:
Certain cleaning chemicals can damage
plastic parts.
6. Avoid use of cleaning chemicals or solvents,
ammonia and household detergents containing
ammonia.
BLADE RAISING AND TILTING MECHANISM
(FIG. UU)
After every five hours of operation, the blade raising
mechanism and tilting mechanism should be checked
for looseness, binding, or any other abnormalities.
1. With the saw disconnected from the power source,
turn the saw upside down and pull up and push
down on the motor unit.
2. Observe any movement of the motor mounting
mechanism.
3. Place a small amount of dry lubricant on the bevel
gear (1). The worm gear (2) must be kept clean and
free of sawdust, gum, pitch, and other contaminants
for smooth operations.
NOTE: If excessive looseness is observed in any part of
the blade raising mechanism or tilting mechanism, take
the complete unit to a Service Centre.
LUBRICATION
All motor bearings are permanently lubricated at the
factory and require no additional lubrication.
On all mechanical parts of your table saw where a pivot
or threaded rod are present, lubricate using graphite or
silicone. These dry lubricants will not hold sawdust as
would oil or grease.
Fig. UU
WARNING
!
WARNING
!
2
1