Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 31 / 38

31
TROUBLESHOOTING GUIDE
To avoid injury from an accidental start, turn the switch OFF and always remove the plug from the power
source before making any adjustments.
●
If for any reason the motor will not run, contact the Rona Service Centre.
WARNING
!
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
Saw will not start. 1. Saw is not plugged in.
2. Fuse blown or circuit breaker tripped.
3. Cord is damaged.
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cord replaced by Service Centre or
Authorized
Service Station.
Does not make
accurate 45° and
0° rip cuts.
1. Positive stop not adjusted correctly.
2. Tilt angle pointer not set accurately.
1. Check blade with square and adjust positive
stop.
2. Check blade with square and adjust to zero.
Material pinched blade
when ripping.
1. Rip fence not aligned with blade.
2. Warped wood, edge against fence is not
straight.
1. Check and adjust rip fence.
2. Select another piece of wood.
Material binds on riving
knife.
1. Riving knife not aligned correctly with blade. 1. Check and align riving knife with blade.
Saw makes
unsatisfactory cuts.
1. Dull blade.
2. Blade mounted backwards.
3. Gum or pitch on blade.
4. Incorrect blade for work being done.
5. Gum or pitch on blade or table causing
erratic feed.
1. Replace blade.
2. Turn the blade around.
3. Remove blade and clean with turpentine
and coarse steel wool.
4. Change the blade.
5. Clean blade or table with turpentine and
steel wool.
Material kicked back
from blade.
1. Rip fence out of adjustment.
2. Riving knife not aligned with blade.
3. Feeding stock without rip fence.
4. Riving knife not in place.
5. Dull blade.
6. The operator letting go of material before it
is past saw blade.
7. Mitre angle lock knob is not tight.
1. Align rip fence with mitre gauge slot.
2. Align riving knife with blade.
3. Install and use rip fence.
4. Install and use riving knife. (with guard)
5. Replace blade.
6. Push material all the way past saw blade
before releasing work.
7. Tighten knob.
Blade does not raise or
tilt freely.
1. Sawdust and dirt in elevation/tilting
mechanisms.
1. Brush or blow out loose dust and dirt.
Blade does not come
up to speed. Reset
trips too easily.
1. Extension cord too light or too long.
2. Low house voltage.
1. Replace with adequate size cord.
2. Contact your electric company.
Machine vibrates
excessively.
1. Saw not mounted securely to workbench.
2. Bench on uneven floor.
3. Damaged saw blade.
1. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace blade.
Does not make accurate
45° and 0° crosscuts.
1. Mitre gauge out of adjustment. 1. Adjust mitre gauge.