Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 25 / 38

25
BEVEL RIPPING
This cut is the same as ripping except the blade bevel
angle is set to an angle other than “0°”.
RIPPING SMALL PIECES
To avoid injury from the blade contact, never make cuts
narrower than 1/2 in. wide.
1. It is unsafe to rip small pieces. Instead, rip a larger
piece to obtain the size of the desired piece.
2. When a small width is to be ripped and your hand
cannot safely pass between the blade and the rip
fence, use one or more push sticks to move the
workpiece. Always use a push stick during ripping
operations.
CROSSCUTTING (FIG. NN)
To prevent serious injury:
●
Do not allow familiarity or frequent use of your
table saw to cause careless mistakes. Remember
that even a careless fraction of a second is enough
to cause a severe injury.
●
Keep both hands away from the blade and the
path of the blade.
●
Never attempt to pull the workpiece backwards
during a cutting operation. This will cause
kickback and serious injury to the user can
occur.
1. Remove the rip fence and place the mitre gauge in
the mitre gauge groove on the table.
2. Adjust the blade height so that it is 1/8 in. higher
than the top of the workpiece.
3. Hold the workpiece firmly against the mitre gauge
with the blade path in line with the desired cut
location. Move the workpiece to a 1 in. distance
from the blade.
4. Start the saw and wait for the blade (1) to come up
to full speed. Never stand directly in line of the saw
blade path, always stand to the side of the blade
that you are cutting on.
5. Keep the workpiece (2) against the face of the mitre
gauge (3) and flat against the table. Then slowly push
the workpiece through the blade.
6. Do not try to pull the workpiece back with the blade
turning. Turn the switch OFF, and carefully slide
the workpiece out when the blade has completely
stopped.
Always position the larger surface of the workpiece
on the table when crosscutting and/or bevel
crosscutting to avoid instability.
USING THE WOOD FACING ON THE MITRE GAUGE
(FIG. OO)
Slots are provided in the mitre gauge for attaching an
auxiliary facing (1) to make it easier to cut very long or
short pieces. Select a suitable piece of smooth wood,
drill two holes through it and attach it to the mitre gauge
with screws. Make sure the facing does not interfere
with the proper operation of the sawblade guard. When
cutting long workpieces, you can make a simple outfeed
support by clamping a piece of plywood to a sawhorse.
BEVEL CROSSCUTTING (FIG. PP)
0°~45° BLADE BEVEL & 90° MITRE ANGLE
This cutting operation is the same as crosscutting
except the blade is at a bevel angle other than 0°.
Always work to the right side of the blade during
this type of cut. The mitre gauge must be in the right
side groove because the bevel angle may cause the
blade guard to interfere with the cut if used on the
left side groove.
1. Adjust the blade (1) to the desired angle, and tighten
the blade bevel lock knob.
2. Tighten the mitre lock handle (2) at 90°.
3. Hold workpiece (3) firmly against the face of the
mitre gauge throughout the cutting operation.
3
2
1
1
Fig. NN
Fig. OO
1 3
2
Fig. PP
WARNING
!
WARNING
!
WARNING
!