Haussmann X-pert 89335002, Инструкция по эксплуатации

Страница: 2 / 38

2
PRODUCT SPECIFICATIONS
TABLE OF CONTENTS
MOTOR SAW
Type .................................................... Universal Rip Capacity ........................... 24-1/2 in. (622 mm)
Right of blade
Amps ................................................... 15 Blade Size .............................. 10 in. (254 mm)
Voltage ................................................ 120 Blade Arbour Size ..................... 5/8 in. (15.9 mm)
Hz ........................................................ 60 Maximum Cut Depth @ 90° ..... 3-1/8 in. (88 mm)
RPM (no load) ..................................... 4000 Maximum Cut Depth @ 45° ..... 2-7/16 in. (62 mm)
Overload Protection ............................ YES Maximum Diameter Dado ....... 8 in. (203.2 mm)
(Stackable only)
Maximum Dado Cut Width ...... 13/16 in. (20.63 mm)
SECTION PAGE SECTION PAGE
Product Specifications........................................... 2 Glossary of Terms......................................... 13
Safety Symbols..................................................... 3 Assembly and Adjustments........................... 14
Power Tool Safety................................................. 4 Operation...................................................... 23
Table Saw Safety.................................................. 6 Maintenance................................................. 28
Electrical Requirements and Safety...................... 9 Push Stick Pattern......................................... 30
Accessories and Attachments............................... 10 Troubleshooting Guide.................................. 31
Tools Needed for Assembly................................. 10 Warranty........................................................ 32
Carton Contents.................................................... 10 Parts List....................................................... 33
Know Your Table Saw........................................... 12
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 120 Volt operation. It must be connected to a 120 Volt / 15 Ampere time
delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these safety rules. Failure to follow these
rules could result in serious injury to you or damage to the tool.
2010/12
WARNING
!