• Basically, the cPH2 is designed for operation in high ambient temperatures.
Nevertheless, it is recommended to install the charging station, if possible, in a way
that it is protected from direct sunlight: this prevents excessive heating of the
housing. For more information on environmental conditions, refer to the "Technical
data" section on page 24.
• The charging points and holding devices for the charging plugs should be
between 0.4 m and 1.5 m above the ground.
Wall mounting of the charging station
For the assembly you need the following components:
• Drilling machine or cordless screwdriver (not included in the scope of delivery)
• Drill Ø 10 mm for the respective mounting surface (not included in the scope of
delivery)
• Torx screwdriver TX40 and Allen key 4 mm (not included in delivery)
• Four ASSY-D dowel screws 8.0-80, partial thread, with matching nylon dowels 10 x
56 mm (included in delivery)
• Two M5x16 cylinder screws (included in delivery)
(not included in delivery)
or optionally available cPH2 drill plate as eCharge accessory: Article 3M40777
• If necessary, spirit level (not included in the scope of delivery)
Proceed as follows:
1
Check the dimensions on the drilling template for correctness using a calibrated
meter measure
BEFORE
marking and drilling the holes.
2
Mark the four drill holes on the wall using the drilling template or drill plate and a
spirit level.
3
Drill the marked mounting holes (4x, Ø 10 mm).
4
Insert the dowels supplied.
5
Remove the housing cover of the charging station.
5.1
To do so, unscrew the two screws on the lower side of the cover.
5.2
Carefully lift off the housing cover and then the contact protection cover. To
do this, carefully disconnect the plug connection of the LED indicators on the
touch guard.
6
Place the charging station in position so that the pre-drilled holes in the wall match
those of the cPH2.
7
Now insert the supplied fastening screws and tighten them hand-tight.
This completes the mechanical assembly of the charging station.
Installation and operating manual
cPH2
charging station
Version: 1.0.9
14