•
Use a dry or slightly damp, well-wrung cloth to clean the charging station. Do not use
aggressive cleaning agents, waxes or solvents (such as cleaning gasoline or paint
thinner), as these can cloud the displays or damage the paintwork.
• DO NOT
clean the cPH2 charging station with a high-pressure washer or similar device
that applies high pressure to the surface of the housing.
•
Check the charging sockets of your cPH2 charging station and the optionally available
charging cables at regular intervals for any damage. If the optionally available charging
cables show any damage, please have them replaced immediately: Further charging is
not permitted from this moment on.
DANGER!
If you notice any damage to the housing, the charging sockets or the
associated charging cables after installation, you must take the charging
station out of operation immediately. Contact the service department of
eCharge
!
•
The respective local regulations for the operation of electrical equipment apply at all
times.
Introduction
Thank you for choosing the cPH2 charging station from
eCharge Hardy Barth GmbH
!
With this Wallbox you invest in an innovative and future-proof solution for the private
and public sector to charge your electric vehicle reliably and intelligently.
The Wallboxes of the cPH2 series are delivered pre-configured for a minimum of
technical and temporal installation effort, for an appropriately prepared installation site.
Our charging stations are subject to permanent further development and comply with
the regulations and standards applicable throughout Europe for the charging of electric
vehicles. Please also read the section "Standards & Guidelines" on page 26.
Installation and operating manual
cPH2
charging station
Version: 1.0.9
8
