Charging process
The cPH1 is designed to charge your vehicles as fast as possible according to IEC
61851-1 Mode 1 (upon using the Schuko plug socket) or IEC 61851-1 Mode 3. The
effective charging time depends on the battery of your vehicle as well as on the
current residual energy. Therefore, it is not possible to give a binding statement
regarding the charging time.
In fact you will determine the data upon practice and thus, develop your own
personal schedule for charging.
To charge your vehicle proceed as follows:
1.
Check the LED-Display on the front of your charging station. If the charging station
is ready, the LED lights are glowing green.
2.
Open the charging socket of your vehicle.
3.
Plug the charging cable (of either Type 1 or Type 2) into the charging socket of
your vehicle. Park the EV accordingly so you can reach it comfortably. During the
charging process the cable
MUSTN‘T
be strained.
4.
Open the cover of your charging socket of the cPH1 if available with your variant
and plug in your Type 2 charging cable.
PLEASE NOTE!
If the used charging plug socket does not require RFID authentication,
the charging process will start immediately. In this case skip step 5 and
5.
Register with your RFID identification card by placing the card in front of the
marked spot of the RFID module on the cPH1.
Find more details at paragraph ”RFID-module” on page 27.
6.
Start of charging process
6.1 Standard operation
In case of standard configuration the charging process will start immediately after
a successful registration by the RFID identification card. The colour of the LED-
Display will change from green to blue as soon as the charging process begins.
Instruction Manual
cPH1
charging station
Version: 1.2.4
21
