Please proceed as follows:
•
Take off the front cover of the housing by unscrewing the 2 screws in the
corners
◦
unscrew the screws fastened in the lower part of the front panel.
◦
remove the panel by lifting it carefully.
•
Mark four drill holes on the wall.
•
Drill the previously marked spots (Ø 10 mm).
•
Insert the included screw anchors for the fastening screws.
•
Position the charging station so the drilled holes of the wall tally with the
ones of the cPH1.
•
Now insert the fastening screws and tighten them.
The mechanical installation is now complete.
Electrical installation of charging station
DANGER!
Danger to life due to electric shock!
Before working with the cPH1 charging station:
Disconnect the electrical power supply and make sure that it stays
disconnected non-stop through the whole installing process.
After completion of the mechanical installation the charging station will be connected
to the power line. In the following, instructions on how to connect additional
accessories are not shown in this manual as it focuses on the basic installation
process. You can find instructions for the accessories in separate manuals of the
respective component.
For the electrical installation, the following tools will be needed:
•
A screwdriver, TX25 (not included in scope of delivery)
•
Stripping tongs
(not included in scope of delivery)
Instruction Manual
cPH1
charging station
Version: 1.2.4
16
