Hardi ISOBUS VT, Руководство оператора

Страница: 88 / 104

11 - Fault finding
11.10
90 Reminder Grease misc. Periodically, period defined in extended menu.
(Only checked at power up) The track system now needs to be lubricated.
Yellow labels indicate lubrication points otherwise
see operators’ manual.
100
91 Reminder Miscellaneous service Periodically, period defined in extended menu.
(Only checked at power up) See operators’ manual for specific sprayer service. 101
92 Reminder Check nozzles Periodically, period defined in extended menu.
(Only checked at power up) You need to check the individual nozzle flow per
minute.
A stopwatch and good quality measuring jug is
needed.
Do the test with clean water.
Nozzles with over 10% of rated new capacity must
be discarded.
102
93 Reminder Stop watch is zero Stop watch is zero 103
94 Changed Track in manual Operator has put Track in manual 104
95 Changed Track in auto Operator has put Track in auto 105
96 Changed Track is locked Operator has locked Track 106
97 Changed Reversing Operator is reversing 107
98 Changed Track unlocked Lock is detected released.
Hydraulic pressure established. Mis adjusted lock
sensor.
108
99 Alarm PrimeFlow data cable weakness JobCom does not receive the data it sends.
Shift the relay to Full duplex (transmit to both ends).
Data cable defect is only detected at Half duplex
(listen only right end).
No further Data cable defect are detected at Full
duplex (transmit to both ends).
PrimeFlow bus cable fault is detected.
A failure handling circuit is enabled.
PrimeFlow is in full operation.
35
100 Alarm Low PrimeFlow voltage JobCom measure PrimeFlow supply voltage after
fuse for left and right boom part at AI11 and AI12.
Alarm occur when voltage is below 14 volts.
A fuse is open or too many rapid shifts on and off of
sections has drained the power supply. 36
101 Warning PrimeFlow power cable defect Low power warning from SMCU, when supply is re-
established.
First low power warning received after power up of
system is not valid.
First low power warning received after “Low voltage
on supercap” is not valid.
Poor power wiring to PrimeFlow computers. One of
the 2 power lines are disconnected or connectors
are corroded and gives high resistance. 109
102 Warning PrimeFlow computer defect SMCU does not reply on status.
No status request while “Low voltage on supercap”
occurs.
Internal fault in PrimeFlow computer. Can also be
caused by 2 or more defects in PrimeFlow data
cable. Check for PrimeFlow data cable weakness. 110
103 Warning Fold with unlocked pendulum When pressing FoldCenterIn, FoldLeftIn or
FoldRightIn and pendulum is unlocked. Fold with unlocked pendulum. 111
104 Warning Boom wing loose Buttons FoldLeftIn or FoldRightIn are not pressed
but the 4 sensors on outer boom wings change
from “In spray” to “Not in spray” respectively when
they change from “In transport” to “Not in
transport”. Boom wing loose. 112
105 Changed Agitation in Auto Forward speed > 0.5 km/h and Main On/Off = On Agitation in Auto 113
106 Warning Regulation valve in end-stop Warning appears when pressure regulation
algoritm tries to close Regulation valve to increase
pressure, but encoder does not give any signals, as
micro switch has turned of motor.
Alarm should not appear at self test at start up.
Pressure regulation is unchanged.
JobCom detected that pressure regulation valve
does not turn and cannot close and increase
pressure and flow any further.
Increase PTO RPM.
Review flow used for agitation.
Check for internal leakages.
114
ID Type Text at display detail Criteria for fault
Operations disabled
Full screen Help text Pr