Hardi ISOBUS VT, Руководство оператора

Страница: 59 / 104

7 - Menu 3 Calibration
7.7
Menu 3.3.4 End nozzles and Bi-jet (optional)
If end nozzles or Bi-jet are fitted, it should be set up corresponding to the
number of boom nozzles it covers.
1.
In menu [3.3 Boom setup] go to the menu [3.3.4 End nozzles and
Bi-jet].
2.
Press Enter.
3.
Select submenu corresponding to the type of end nozzle:
4.
Press Enter.
5.
In the sub menus [3.3.4.2] and [3.3.4.3] set the value to the equivalent coverage by the boom nozzles. E.g. end nozzle
coverage is 5 feet. This is equal to 3 boom nozzles.
˜
ATTENTION! It is important that the volume applied from the end nozzle matches the volume applied under the
boom, i.e. end nozzles mounted must have the same ISO size as the regular nozzles on the boom. This is a comparison
of volume per minute per length (Gallons/min/inches).
When the end nozzle is active, the area covered and volume sprayed is calculated and registered. If “Active boom
size” is displayed, it will show an increase when the end nozzle is activated.
The table below is based on data from the Hardi® Nozzle product guide and is valid at 45 psi (3 bar).
Menu 3.3.5 Length hitch to axle for ASC
Set length from the tractor’s hitch eye to the sprayer’s wheel axle. The
distance is used when determining the path of the spray rig as it moves
around in the field.
˜
ATTENTION! This menu is only for sprayers equipped with ISOBUS
and AutoSectionControl.
Menu Function
3.3.4.1 None
3.3.4.2 End nozzles fitted
3.3.4.3 Bi-jet fitted
End nozzles Width (inches) Total flow/nozzle (gpm) Equivalent ISO nozzle size 20” flow/nozzle (gpm)
1850 End nozzle 3/8” - SYNTAL
1850 G-150 61 0.274 Pink ISO 0075 0.09
1850 G-200 77 0.449 Orange ISO 01 0.12
1850 G-250 98 0.777 Green ISO 015 0.16
1850 G-300 110 0.970 Green ISO 015 0.18
1850 G-350 116 1.480 Lilac ISO 025 0.26
1850 G-400 136 2.039 Blue ISO 03 0.30