HANGCHA XE Series, Руководство по эксплуатации и обслуживанию

Страница: 70 / 82

66
new brake fluid as the level drops.
Caution
Prevent dust and water from mixing with the
brake fluid when adding it.
Brake fluid is toxic and corrosive and should
be rinsed off if you are exposed to it.
3. Check the built-in friction block in the side
shifter
1. Remove the pin at the piston rod end of
the side-shifting cylinder.
2. Remove the four bolts of the left, right and
down friction blocks, and remove the down
friction block (pay attention to the
adjustment pad inside).
3. Push the beam under the side-shifting
frame forward slightly and lift the
side-shifting frame upwards.
4. Check the thickness of the friction block
and replace the friction block with a new one
when the wear relative to the initial size is
greater than 2 mm.
6.6 Annual maintenance (2,000
hours)
Add the following maintenance items in addition
to the semi-annual maintenance.
1. Change the front wheel bearing lubricating
grease
Refer to the drive axle hub content in the
Maintenance Manual, disassemble the wheel
bearing, and then change the grease.
2. Change the rear wheel bearing lubricating
grease
Refer to the content on the steering axle in the
Maintenance Manual.
3. Change the lubricating grease for the entire
forklift truck
4. Replace the hydraulic oil
Warnings
Hot hydraulic oil and components may scald
the human body. Do not touch hot
hydraulic oil or associated components.
Operating steps:
– Park the truck according to rules and
regulations.
– Tilt the mast to its limit and lower the
forks to the ground.
–
Remove the rubber pad from the base
plate.
– Remove the rear base plate.
– Unscrew the hydraulic oil tank lid and
dipstick assembly.
–
Place an oil container under the frame,
unscrew the oil drain plug and sealing gasket,
and drain out the old oil;
– Take away the oil container, handle the
waste oil according to local environmental
regulations, do not dump it arbitrarily;
– Screw in the oil drain plug and sealing
gasket, add new hydraulic oil, check whether
there is leakage;
–
Start the forklift truck, lift the forks 3 - 5