HANGCHA XE Series, Руководство по эксплуатации и обслуживанию

Страница: 33 / 82

29
carrier.
-
The fork clearance is adjusted.
-
1
2
3
Caution

The fork stop dowel must be locked
(in the card slot of the fork arm carrier), if
it is not locked, the fork can easily move
while driving the forklift truck, and the
cargo may fall.

Be careful to prevent fingers from
being clamped when adjusting a fork.

In order to ensure safe operation in
the picking process, the distance between
the forks should be as large as possible,
and the position of the forks must be
symmetrical with the center line of the
fork arm carrier. The center of load must
be located in the middle of the fork
clearance.
2. Disassembly of forks:
Caution

There is an opening on the lower
beam of the fork arm carrier for loading
and unloading forks.

Do not fasten the fork in the open
position of the fork arm carrier to prevent
the fork from falling off from the open
position.

There is a bolt in the middle of the
upper beam to prevent the fork from
working there. If the bolt is damaged, it
should be replaced as soon as possible.
When the fork needs to be replaced, the operator
should unscrew the fixing bolt in the middle of the
fork arm carrier, move the fork to the opening in
the middle of the cross-beam of the fork arm
carrier, and then tilt forward and lower the fork
until the fork is free from the fork arm carrier,
then move the vehicle back.
3. Installation of the fork:
Place the forks on the ground against the forklift,
lower the fork arm to the bottom, drive the
forklift slowly, align the upper and lower slots of
the forks with the upper and lower beams and
gaps of the fork arm, lift the fork arm slowly, and
adjust the position of the forks.
2.4 Starting the truck
Prerequisite: Checks and adjustment before
operation has been performed on the forklift
truck.