HANGCHA XE Series, Руководство по эксплуатации и обслуживанию

Страница: 66 / 82

62
both directions and check whether the wheel
position is displayed on the instrumentation.
16. Check the driver's seat switch
When the driver is not sitting in the driver's seat
correctly, the driver's seat switch indicator light on
the instrument will light up and the hydraulic
functions will be disabled.
17. Tire check and tire pressure check (pneumatic
tires)
Screw the cap back on after confirming that there
is no air leakage; check whether there is damage
on the tire surfaces and sides and whether the
rims are deformed.
Unscrew the cap anticlockwise and measure the
tire pressure with an air pressure gauge. Increase
the pressure to the specified value if it is
insufficient.
Warning
The forklift truck tires require very high
pressure to bear loads; tiny deformation
of the rim or surface damage to the tire
may cause an accident.
• When using an air compressor, as the
maximum output pressure of the air
compressor is higher than the specified
pressure of tire, the pressure setting
should be adjusted first, see the following
table
for pressure values; over
pressurizing may cause a serious accident.
In order to ensure safety, the tire should
be placed in a protective frame during air
inflation.
18. Check the lithium-ion battery
See 5.5 "Daily maintenance of the lithium-ion
battery" for details.
6.2 Weekly maintenance (40 hours)
Add the following maintenance items in addition
to daily maintenance.
1. Mast and fork check
Check the mast and forks to ensure that:
(1) The forks are not cracked or bent and are
firmly and correctly mounted on the fork arm;
(2) Check the oil cylinder and oil pipe for any oil
leakage;
(3) Check the rotation of the rollers;
(4) Check whether there are cracks or
deformation in the mast;
(5) Manipulate the lifting, tilting, and
attachment handle to check whether the mast
works normally and whether there are any
abnormal noises.
2. Chain tension check
(1) Raise the fork by 10 cm - 15 cm with the
mast in the vertical position.
(2) Press the middle of the chain with your
thumb to check whether the tension of the left
and right chains are the same.
(3) Tension adjustment: loosen locknut 1, turn
nut 2 to adjust the chains so that the tension of
the two chains is the same, and then tighten
locknut 1.