Hamilton Jet HJ212, Инструкция по установке и обслуживанию

Страница: 86 / 198

Overhaul
Installation and Service Manual
Care of Jet Unit Paintwork
For detailed information on the jet unit paint work, Refer to section: Jet surface coating procedure on page 8-
2.
Anti fouling Paints
Do not apply copper oxide based anti-fouling paints.
Do not paint over the anodes.
Torquing Sequence of Nuts
Flange nuts must be tightened in the correct sequence
so that the flange pulls up square.
Where no specific sequence is given in the manual, do
the following:

Fit 4 nuts (top, bottom, left side, right side) and
tighten each 1 turn at a time until the flanges pull
together.

Fit all remaining nuts and hand tighten only.

Working around the flange, in a crosswise sequence
as shown, Tighten nuts to the specified torque. Refer
to section: Tightening Torques on page 10-28.

Repeat the above torquing sequence until no further
movement of the nut occurs.
Anode Replacement
Replace the anode if more than 2/3 corroded:
Clean the end face of the anode insert, anode and spring washer
mating faces [A] using an abrasive cloth (Scotch-Brite™) or emery
paper [B].
Mount the anode on the stud.
Refit the spring washer and nut using Loctite
®
243.
Tighten nuts to the specified torque. Refer to section: Tightening
Torques on page 10-28.
Some anodes are fastened with nyloc nuts. Once removed, these
nuts must be discarded and replaced with new nyloc nuts when
refitting.
9-4