Hamilton Jet HJ212, Инструкция по установке и обслуживанию

Страница: 124 / 198

Appendix
Installation and Service Manual
Water Offtake Bungs and Hose Tails
Loctite Colour Primer, Activator, Accelerator Loctite Cure Speed
567 White Type Drying Time Partial Full
Accelerator 7649 30-70 Sec With Primer 2 Hrs 6 Hrs
(Optional) Without Primer 12 Hrs 24 Hrs
Water offtake bungs & hose tails (thread sealant).
Accelerator is used where cure speed is unacceptably long.
1 - Apply optional accelerator to thread of plug or hose tail and allow to dry.
2 - Do not apply accelerator to brass hose tails.
3 - Apply Loctite to thread engagement area of the plug or hose tail leaving the
first thread Loctite free.
Screw plug or hose tail into tailpipe until plug or hose tail bottoms and tighten
firmly.
Unpainted Bores, D-Glide Bushes
Loctite Colour Primer, Activator, Accelerator Loctite Cure Speed with Primer
Activator, Accelerator
325 AMBER Type Drying Time Partial Full
Activator 1-3 Min 5 Min 24 Hrs
7075
D-glide bush retention (high strength adhesive).
Activator will be used in all retaining applications.
325 Loctite will not cure without the activator.
1 - Apply activator to outside of bush and allow to dry.
2 - Apply adhesive to whole surface of bore.

There are to be no dry areas between bush and bore.
Press bush into bore within 15 minutes.
Mainshaft Nuts Without Locking Devices
Loctite Colour Primer, Activator, Accelerator Loctite Cure Speed
243 BLUE Type Drying Time Partial Full
Primer 7471 30-70 Sec With Primer 10 Min 2 Hrs
(Optional) n/a Without Primer 20 Min 6 Hrs
Mainshaft nuts (medium strength thread locking).
Primer is used to shorten the cure time when the temperature is below 15°.
1 - Apply optional primer to the threads on the mainshaft and allow to dry.
2 - Apply Loctite to the thread engagement areas of the mainshaft in sufficient
quantity to fill all engaged threads.
Assemble nuts to `jet specific' torque specifications.
10-8