HAKO Citymaster 2000, Инструкция по эксплуатации и обслуживанию

Страница: 26 / 186

2-10
X56b210.fm
Safety instructions
•
Always tighten any screwed connections that have been loosened
during maintenance and repair!
•
Any safety devices removed for set-up, maintenance or repair purposes
must be refitted and checked immediately upon completion of the
maintenance and repair work.
•
Ensure that all consumables and replaced parts are disposed of safely
and with minimum environmental impact!
•
Do not use work equipment as lifting platforms for persons, except for
the lifting platform itself!
•
Perform maintenance and repair work beneath a raised vehicle, work
equipment/implements or additional equipment only if a safe and
secure support has been provided for (the sole use of hydraulic
cylinders, jacks, etc. does not sufficiently secure raised vehicles or
equipment/implements).
•
Avoid contact with hot parts, such as the engine block or the exhaust
system during the operation of the vehicle and for some time afterwards
– risk of burns!
•
Do not use starting fuel! This especially applies to those cases in which
heater plugs (intake-air preheating) are used at the same time – risk of
explosions!
•
Apply special care when working on the fuel system – increased risk of
fire!
2.7 Warning of special hazards
Electric energy
•
Use only original fuses with the specified current rating!
Switch off the vehicle immediately and rectify malfunction if trouble
occurs in the electrical system!
•
Work on the electrical system may only be carried out by a skilled
technician, in accordance with the applicable electrical engineering
rules.
•
Inspect and check the electrical equipment of the vehicle at regular
intervals. Defects such as loose connections or scorched cables must
be rectified immediately.
•
Observe the operating voltage of the vehicle/implements!
•
Always remove the earthing strap from the battery when working on the
electrical system or when performing welding work!
•
Starting with a battery jump cable can be dangerous if performed
improperly. Observe the safety instructions regarding the battery!
Gas, dust, steam, smoke
•
Operate the vehicle only on adequately ventilated premises! Before
starting internal combustion engines or operating fuel-operated heating
systems on enclosed premises, make sure that there is sufficient venti-
lation!
Observe the regulations in force at the respective site!
•
Carry out welding, flame-cutting and grinding work on the vehicle only if
this has been expressly authorised. For For example, there may be a
risk of explosion and fire!
•
Before carrying out welding, flame-cutting and grinding work, clean the
vehicle and its surroundings from dust and other inflammable
substances, and make sure that the premises are adequately
ventilated – risk of explosions!