26 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
4.
Open the machine guard
and raise the splitting
groove support arch C to
the upper position (as
instructed
in
Section
3.1.2.).
5.
Connect the hook of
winch D to the splitting
blade’s lifting hole E, as
shown in Figure 21.
6.
Use the winch to lift the
splitting blade out of its
place, guide the splitting
blade out from the out-
feed conveyor’s side and
lower it carefully onto a
fork
lift
pallet,
for
example.
Install a new splitting blade by
completing the steps in reverse
order.
Figure 21.
4.4.2.
Adjusting the stroke length of the splitting motion
In the Hakki Pilke 50 Pro firewood processor, the splitting cylinder is controlled electrically with sensors A
and B in Figure 22. The stroke length of the splitting cylinder can be adjusted as follows:
1.
Shut down the machine and disconnect it from its power sources.
2.
Remove the machine’s cover plate (from the rear of the machine), as shown in Figure 22.
3.
Sensor A (Figure 22) determines the spot in which the splitting beam stops during the return
motion. If necessary, change the position of the sensor. Loosen the sensor’s fastening bolt, move
the sensor and tighten the bolt to secure it in place.
