11 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
3.1.2.
Placing the out-feed conveyor in the operating or transport position
Place the out-feed conveyor in
the operating position as
follows:
1.
Ensure that there is
sufficient room for
opening the out-feed
conveyor.
2.
Keep locking latch A,
shown in Figure 7, open
and lower the out-feed
conveyor hydraulically
by turning lever D (in
Figure 10) to the right.
Note! Leave sufficient
clearance
(approx.
30 cm) for the discharge
opening
of
the
conveyor.
3.
Turn the upper section
of the conveyor to the
operating position with
the handle(s) B (Figure
8).
Note! If necessary,
have two people on
either side of the
conveyor to lift it!
4.
Lock the upper section of
the conveyor into place
with latch C and cotter
pin D, as shown in Figure
9.
5.
Turn the support bar (E
in Figure 9) of the
conveyor belt to the
operating position.
Figure 7.
Figure 8.
Figure 9.
