18 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
3.2.4.
Using the out-feed conveyor
The Hakki Pilke 50 Pro firewood processor’s out-feed conveyor belt is driven by a hydraulic motor. To
change the speed of the belt, use adjuster C in Figure 17. The conveyor angle can be changed
hydraulically in the horizontal and vertical directions by using lever D shown in Figure 17:
-
Lever forwards: the conveyor turns to the left
-
Lever backwards: the conveyor turns to the right
-
Lever to the left: the conveyor’s angle to the ground increases
-
Lever to the right: the conveyor’s angle decreases
Figure 17.
By using lever B (Figure 17), you can stop the conveyor (middle position) and, if necessary, reverse the
conveyor belt for a short distance (approx. 1 m) by pulling the lever back if a piece of wood is stuck
between the conveyor cleaning plate and the upper roller, for example.
NOTE! The maximum operating angle for the out-feed conveyor is 40°. The maximum angle is indicated
in the label below and the instructions attached to the out-feed conveyor.
