29 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
4.
Clean the machine.
If you will not be using the firewood processor for a while, do the following:
5.
As necessary, use your tractor's hydraulics or a forklift to hoist the firewood processor and
carefully move it to a location where you can place the in-feed and out-feed conveyors into their
transport and storage position.
6.
Place the conveyors into the transport and storage position.
7.
Clean the machine and carry out any maintenance.
8.
Store the machine according to the instructions in Section 10.
5.
Machine maintenance
The machine must be disconnected from its power source before any maintenance, adjustment,
replacement or cleaning measures. Only use spare parts that are supplied by the manufacturer or your
retailer. If the guards of the machine have to be removed for maintenance, they must always be
reattached before the machine is activated. After maintenance and adjustment measures, the machine
must be test run according to the instructions in Section 4.1.
5.1.
Cutting blade and drive end
If the cutting blade of the machine does not penetrate the wood properly or the cut is skewed, the saw
chain is most likely blunt or the saw bar is bent.
The most common cause for problems with cutting logs
is an unevenly dulled saw chain which veers 5–10 cm to either side and causes the saw bar to stop.
It is
a good idea to keep a replacement chain on hand, so that you do not need to interrupt your work to
sharpen the chain.
