16 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
3.2.2.
Electrical drive
An electrically powered machine is
driven by a 15 kW electric motor. The IP
rating of the electric motor is 55. The
fuse must be at least a 32 A type C fuse.
The electrical cable must be at least 5 x 6
mm², and the recommended maximum
length is 25 metres. In order to connect
the cable, move protective cover B of
socket A and the multiplier gear and
secure it into a position where it covers
the multiplier gear.
In an electrically powered machine, the
power cable for the electric controls is
connected to the 3-pin socket on the
side of the machine.
The electrically powered machine is
turned on with the green button of the
remote starter, located in the control
panel in the front of the machine (Figure
15). The actual starter is located behind
the machine’s rear cover. The starter
features an automatic fuse and a thermal
relay for the electric motor. The thermal
relay can be reset by pressing the red
stop button on the starter at the rear of
the machine.
If the electric motor rotates in the wrong
direction (i.e. the machine makes an
abnormal noise and the hydraulic
functions are inoperable), the current
phase is incorrect.
You can turn the gear with switch C in
Figure 13 by rotating it 180 degrees.
Figure 13. The machine’s electrical drive
Figure 14. Electrical connector of the electric control
device
Figure 15. The machine’s remote starter
