Haemonetics MCS+, Руководство оператора и по техническому обслуживанию

Страница: 75 / 112

Notice Messages and Troubleshooting 5-15
P/N 39551-00, Rev. F
257
PRESSURE PROBLEM
HIGH PRESSURE ERROR AT THE DPM.
The DPM high pressure limit was exceeded.
1. Check tubing for occlusions.
2. Check tubing for closed clamps.
3. Check tubing at valves.
4. Check tubing at pumps.
5. Resume operation.
258
PRESSURE PROBLEM
LOW PRESSURE ERROR AT THE DPM.
The DPM low pressure limit was exceeded.
1. Check tubing for occlusions.
2. Check tubing for closed clamps.
3. Check tubing at valves.
4. Check tubing at pumps.
5. Resume operation.
259
PRESSURE PROBLEM
SPM HIGH PRESSURE ERROR.
The SPM high pressure limit was exceeded.
1. Check tubing for occlusions.
2. Check tubing for closed clamps.
3. Check tubing at valves.
4. Relieve pressure by opening WHITE valve.
NOTE: The product shelf life becomes
24 hrs if the SPM filter is wet.
260
PRESSURE PROBLEM
THE SPM PRESSURE WAS TOO LOW.
The SPM low pressure limit was exceeded.
1. Check tubing for occlusions.
2. Check tubing for closed clamps.
3. Check tubing at valves.
4. Check that product bags have not
collapsed.
261
PROCESS PROBLEM
DRAW not allowed, press RETURN to continue.
Cycle was interrupted with a full bowl.
The MCS+ device cannot achieve re-separation.
Press RETURN to continue.
262 DOOR OPEN
THE PROTOCOL CARD DOOR IS OPEN.
1. Close the Protocol Card door.
2. Resume operation.
NOTE: DO NOT remove/insert cards during
operation of the MCS+ device.
263 CENTRIFUGE PROBLEM
THE CENTRIFUGE COVER IS NOW LOCKED.
264
DOOR CLOSED
THE PROTOCOL CARD DOOR IS CLOSED.
1. Ensure the door stays closed.
2. Continue operation.
NOTE: DO NOT remove/insert cards during
operation of the MCS+ device.
265
SYSTEM PROBLEM
PUMP MANIFOLD NOT INSTALLED.
The white pump manifold
is not snapped in place.
1. Snap manifold in place.
2. Check pump tubing installation.
3. Resume operation.
# Notice Messages Help Messages