Haas 96-8000, Руководство оператора

Страница: 199 / 269

190 96-8000 Rev AC
May 2010
G153 5-Axis High Speed Peck Drilling Canned Cycle (Group 09)
E Specifies the distance from the start position to the bottom of the
hole
F Feedrate in inches (mm) per minute
I Size of first cutting depth (must be a positive value)
J Amount to reduce cutting depth each pass (must be a positive
value)
K Minimum depth of cut (must be a positive value)
L Number of repeats
P Pause at end of last peck, in seconds
Q The cut-in value (must be a positive value)
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position
.
E E
I
1
=I
I
2
=
I
1
-
J
I
3
=I
2
-J Q
Q
Q
G153 5-Axis High Speed Peck Drilling With I, J & K Options
G153 5-Axis High Speed Peck Drilling With & Q Options K
Setting #22
Setting #22
This is a high-speed peck cycle where the retract distance is set by Setting 22.
If I , J , and K are specified, a different operating mode is selected. The first
pass will cut in by amount I , each succeeding cut will be reduced by amount J ,
and the minimum cutting depth is K . If P is used, the tool will pause at the bot-
tom of the hole for that amount of time.
Note that the same dwell time applies to all subsequent blocks that do not
specify a dwell time.
G154 Select Work Coordinates P1-P99 (Group 12)
This feature provides 99 additional work offsets. G154 with a P value from 1 to
99 activates additional work offsets. For example G154 P10 selects work offset
10 from the list of additional work offsets. Note that G110 to G129 refer to the
same work offsets as G154 P1 through P20; they can be selected by using ei -
ther method. When a G154 work offset is active, the heading in the upper right
work offset will show the G154 P value.