Haas 96-8000, Руководство оператора

Страница: 68 / 269

59
96-8000 Rev AC
May 2010
Operation
selected column.
t
yPical
W
orK
o
ffSet
S
et
-
UP
1. Place the material in the vise and tighten.
2. Load a pointer tool in the spindle .
3. Press Handle Jog (A).
4. Press .1/100. (B) (The mill will move at a fast speed when the handle is
turned).
5. Press +Z (C).
6. Handle jog (D) the Z-axis approximately. 1” above the part.
7. Press .001/1. (E) (The mill will move at a slow speed when the handle is
turned).
8. Handle jog (D) the Z-axis approximately. 0.2” above the part.
9. Select between the X and Y axes (F) and handle jog (D) the tool to the upper
left corner of the part (See the following illustration).
10. Press Offset (G) until the Work Zero Offset Pane is active.
11. Cursor (I) to G54 Column X.
12. Press Part Zero Set (J) to load the value into the X-axis column. The sec
-
ond press of Part Zero Set (J) will load the value into the Y-axis column.
CAUTION! aDo Not Press Part Zero Set a third time; doing so will load a value into
the Z-axis. This will cause a crash or Z-axis alarm when the program is run.
.
Spindle at top left of the front
A
D F
H B
E I
C G J
Setting the Tool Offset
The next step is to touch off the tools. This defines the distance from the tip of
the tool to the top of the part. Another name for this is Tool Length Offset, which
is designated as H in a line of machine code; the distance for each tool is en-
tered into the Tool Offset Table.