Haas 96-8000, Руководство оператора

Страница: 249 / 269

240 96-8000 Rev AC
May 2010
This message is not an alarm and does not interfere with machine operation in
any way. After the necessary maintenance has been performed, the operator
can select that item on the “Maintenance” screen, press the Origin button to
deactivate it, then press Origin again to reactivate it with the default number of
hours remaining.
Refer to settings 167-186 for additional maintenance defaults. Note that set-
tings 181-186 are used as spare maintenance alerts by keying-in a number.
The maintenance number will display on the Current Commands page once a
value (time) is added to the setting.
W
indoWS
/ G
UardinG
Polycarbonate windows and guarding can be weakened by exposure to cutting
liquids and chemicals that contain amines. It is possible to lose up to 10% of
the remaining strength annually. If degradation is suspected, replace the win-
dow. It is recommended that the windows be replaced every two years.
Windows and guarding should be replaced if damaged or severely
scratched. Replace damaged windows immediately.
W
orKliGht
There are four types of worklights for the Haas mills. Turn off power to the ma -
chine at the main breaker before doing any work on the mill.
.
Glass
Frame
Screw
Screws Retainer Lens
Lens
Lens
The power for the worklight comes from the GFI circuit. If the worklight does
not turn on, check this first, it can be reset at the side of the control panel.
c
hiP
a
UGer
During operation, most chips are collected from the machine at the discharge
tube. However, very small chips may flow through the drain and collect in the
coolant tank strainer. To prevent drain blockage, clean this strainer regularly.
Should the drain become clogged causing coolant to collect in the pan, stop
the machine, loosen the chips blocking the drain, and allow the coolant to
drain. Empty the coolant tank strainer, then resume operation.