25
Setting Your Personal Transmitter Code
1. Remove the Transmitter Cover
Grasp the sides of the access cover and slide it away from the
transmitter button (see illustration). When the access cover is removed,
the battery and the DIP switches will be exposed. To set a new code,
use a small screwdriver to move the switches.
, Inc.
, Inc.
, Inc.
All GTO transmitters are set to a standard code at the factory and are ready to activate your automatic gate operator.
For your safety and security, however, we strongly recommend that you replace the factory setting with your own
personal code. Follow the directions below:
2. Set the transmitter DIP Switches
There are nine (9) transmitter DIP switches; each of which can be placed in three
different positions (+, 0, –). DO NOT set all the switches in the same position, such
as all +, all 0, or all –. Once the DIP switches have been set to a personal code,
replace and close the access cover.
WARNING: No other adjustments should be made inside the transmitter.
A.
Turn control box power switch OFF.
B.
Unscrew and remove the control box cover.
C.
Press and hold the LEARN button on the control board,
and turn the power switch ON. Release LEARN
button. Wait 15 seconds for the receiver to charge.
D.
Press and hold transmitter button until the red STATUS
LED comes ON.
E.
Release transmitter button. The new code is stored in
control board memory.
3. "Teach" the New Code to Control
Board Memory
1234
ON
RCVR
SEQ1
SEQ2
LEARN
STATUS
R B G
AUTOCLOSE
INERTIA
OBSTRUCT
SENS.
PULL/PUSH
SNGL/DUAL
MIN
MAX
MIN
OFF
120
60
MAX
STATUS LED
