GST200-2 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
Page 37
6.3.4.2 Enabling Devices
In the screen shown in Fig. 6-14, input number 2, you can enter device enable screen as
shown in Fig. 6-20. Same as disabling devices, you can also enable all devices of a
zone, a single device (single-device enable) , all loop sounders, or enable a device by
user code.
Fig. 6-20
6.3.4.3 Disabling/Enabling Alarm Outputs
Entering number “3” in the screen of Fig. 6-14 will enter the screen for
disabling/enabling alarm output, as shown in Fig. 6-21.
Fig. 6-21
In this screen, the SOUNDER CIRCUIT OUTPUT and FPE OUTPUT on the loop
interface board can be disabled or enabled.
6.3.4.4 Disabling/Enabling Delays
Inputting number 4 in the screen shown in Fig. 6-14 can enter the screen of
disabling/enabling delays, as shown in Fig. 6-22.
Fig. 6-22
In the above screen, you can operate as follows:
Selecting number 1 will disable all delay settings in the system.
Selecting number 2 will enable system to output according to the pre-set delay time,
and light
DELAY MODE
LED.
*Enable Devices*
1 Each Zone Fully
2
Individual Points
3 All Loop Sounder
4 Use Devices Code
* Delay Mode*
1.
Disable
2.
Enable
*Dis/En-able Outputs*
1.
Sounder Circuit
2.
F.P.E. Output
Содержание GST200-2
Страница 1: ......