GSi TopDry Autoflow, Руководство по монтажу

Страница: 23 / 142

Chapter 2: General Overview
Follow the jack manufacturers recommendations on capacity and operations.
3. Lifting brackets must be attached through the stiffener bolt holes. Normally you will need to attach to
at least four (4) bolts per stiffener.
4. Raise the bin just high enough to assemble the next ring. When lifting the bin, all jacks must lift at
an equal rate . Monitor the lift to ensure even lifting is occurring.
5. To the inside of the first ring, bolt the next ring. Be sure to stagger the sheets and select the proper
gauge material.
6. Lower the bin onto the foundation after assembling and tightening bolts on the new ring or rings.
7. Attach stiffeners to the body sheets every two tiers (on the external surface of the bin). You may
want to leave sheets loose to make the attachment of the stiffeners easier.
8. Now re-bolt the lifting brackets to the lowest ring in place thus far. Continue ring additions by
repeating Step 5 and Step 6.
9. Add inside and outside ladders as you continue to raise the bin. (Refer to the manual supplied with
the ladders and platforms.)
10.Add platforms as you raise the bin. (Refer to the manual supplied with the ladders and platforms.)
11.Lower the bin and secure to the foundation before leaving the job site.
12.At the completion of the bin, set stiffeners over the anchor bolts and measure the bin to ensure it is
in a round condition. Consult with GSI for questions on tolerances.
NOTE: For 2 ring doors or vehicle traffic doors, special placement issues may apply. Consult the special
instructions provided with two ring doors or vehicle traffic doors for these options.
Figure 2-1 Lifting jack bracket installation
A
Lifting jack bracket
PNEG-4936 36 Ft. TopDry Autoflow 23