GSi TopDry Autoflow, Руководство по монтажу

Страница: 104 / 142

Chapter 8: Roof Assembly
8. When all roof ring sections (B) are installed, tighten each roof ring clip (B) to the recommended
torque specifications. See bolt torque specification.
9. Adjust each stud nut (G) outward, expanding each roof ring section (B). Continue this procedure
evenly until the roof ring raises the roof, showing a slight crown.
NOTE: Expansion bolts must be fully contracted when assembling support rings. When you have
completely assembled both rings, (but prior to expanding the bolts) tighten all roof bolts
including eave clip bolts. Now extend expansion bolts by running the nut out on the threads.
This procedure must be continued evenly around the roof until the ring raises the roof to
show a slight crown.
NOTE: Roof ring expansion bolts can become dislodged from the roof ring during the life of the bin
due to the influence of wind or other factors. If one expansion bolt is dislodged, the entire
ring will become ineffective. After expansion to the jam nuts final position, the nuts on the
expansion bolt must be secured to prevent this. This can be done by staking the expansion
bolt threads at the jam nut location, or using suitable thread locking compound or other
effective methods.
In addition, drilling holes through the support pipe and expansion bolt and connecting
together with a 1/4 in. diameter bolt is an effective way to prevent the bolt from dislodging
during certain wind and pressure conditions.
Figure 8-11 Exploded view of threaded stud
B Roof ring section (CRP-5363-XX) 7 G Stud nut (S-8926)
F
Threaded stud (S-8765)
104 PNEG-4936 36 Ft. TopDry Autoflow
7. (-XX) denotes the bin diameter.